Table 15. Wireless (continued)
Option Description
All the options are enabled by default.
Wireless Device Enable
Allows you to enable or disable the internal wireless devices.
The options are:
● WLAN
● Bluetooth
All the options are enabled by default.
Post behavior
Table 16. POST Behavior
Option Description
Enable Numlock
The option specifies if the Numlock function should be enabled when the system boots.
The option is set by default.
Enable Adapter
Warnings
Allows you to enable or disable the system setup (BIOS) warning messages when you use certain
power adapters.
● Enable Adapter Warnings—Default
Extended BIOS POST
Time
Allows you to create an additional preboot delay.
Click one of the following options:
● 0 seconds—Default
● 5 seconds
● 10 seconds
Fastboot
Allows you to speed up the boot process by bypassing some of the compatibility steps.
Click one of the following options:
● Minimal
● Thorough—Default
● Auto
Fn Lock Options
Allows you to let hot key combinations Fn + Esc toggle the primary behavior of F1–F12, between
their standard and secondary functions. If you disable this option, you cannot toggle dynamically
the primary behavior of these keys.
● Fn Lock—Default
Click one of the following options:
● Lock Mode Disable/Standard
● Lock Mode Enable/Secondary—Default
Full Screen Logo
Allows you to display full screen logo, if your image matches screen resolution.
● Enable Full Screen Logo
This option is not set by default.
Warnings and Errors
Allows you to select different options to either stop, prompt and wait for user input, continue
when warnings are detected but pause on errors, or continue when either warnings or errors are
detected during the POST process.
Click one of the following options:
● Prompt on Warnings and Errors—Default
126 System setup
To Next Page
Loading...
Need help?
General
