Installing smart card cage
1. Slide the smart card cage into the slot to align with the tabs on the system.
2. Replace the two (M2.0 x 3.0) screws to secure the smart card cage to the system.
3. Affix the smart card cable and connect it to the connector on the system .
4. Install the PCIe SSD card.
5. Connect the battery cable to the connector on the system board.
6. Install the base cover.
7. Follow the procedure in After working inside your computer.
Touchpad buttons board
Removing touchpad buttons board
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Disconnect the battery cable from the connector on the system board.
4. Remove the speaker.
5. Remove the smart card module.
6. To remove the touchpad buttons board:
a. Disconnect the touchpad buttons board cable from the touchpad board [1].
Removing and installing components 27
To Next Page
Loading...
Need help?
General