Installing camera
The installation procedure is applicable only for systems shipping with a nontouch display configuration.
1. Insert the camera module into the slot on the display assembly.
2. Connect the camera cable.
3. Install the display bezel.
4. Install the display assembly.
5. Install the display hinges.
6. Install the display panel.
7. Install the WLAN card.
8. Install the WWAN card.
9. Connect the battery cable to the connector on the system board.
10. Install the base cover.
11. Follow the procedure in After working inside your computer.
NOTE: The two conductive tape pieces must be removed and then reattached when replacing the camera module.
Display Hinge Caps
Removing the display hinge cap
1. Follow the procedure in Before working inside your computer.
Removing and installing components 39
To Next Page
Loading...
Need help?
General