Using the Module Bay
About the Module Bay
Swapping Devices While the Computer Is Turned Off
Swapping Devices While the Computer Is Running
Using the CD or DVD Tray
Adjusting the Volume
Adjusting the Picture
About the Module Bay
You can install devices such as a floppy drive, CD drive, CD-RW drive, DVD drive, DVD/CD-RW drive, Zip
drive, second hard drive, or second battery in the module bay.
NOTICE: To prevent damage to the docking connector, do not remove or replace devices while the
computer is connected to a docking device.
Swapping Devices While the Computer Is Turned Off
Save and close any open files, exit any open programs, and shut down the computer.1.
If the computer is connected (docked) to a docking device, undock it.2.
Close the display and turn the computer over.3.
Slide and hold the latch release, and pull the device out of the bay.4.
NOTICE: To prevent damage to devices, place them in a travel case when they are not installed in
the computer. Store devices in a dry, safe place, and avoid pressing down on them or placing heavy
objects on top of them.
To Next Page
Loading...
Need help?
General