Dell Latitude D410 User Manual

Back to Contents Page
 System Board
Dell™Latitude™D410ServiceManual
Removing the System Board
Replacing the System Board
Removing the System Board
The system board's BIOS chip contains the Service Tag sequence, which is also visible on a barcode label on the bottom of the computer. The replacement kit
for the system board includes a CD that provides a utility for transferring the Service Tag to the replacement system board.

1. Follow the instructions in "Preparing to Work Inside the Computer."

2. Remove the center control cover.

3. Remove the keyboard.

4. Remove the internal card with Bluetooth®wireless technology.

5. Remove the display assembly.

6. Remove the palm rest.

7. Remove the fan.

8. Remove the M2.5 x 5-mm screw that secures the plastic shield to the computer base.

9. Disconnect the smart card reader from the system board.

10. Disconnect the connector of the internal card with Bluetooth® wireless technology from the system board.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed batteries.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
1
M2.5 x 5-mm screw (1)
2
plastic shield

Dell Latitude D410 Specifications

General

Brand	Dell
Model	Latitude D410
Category	Laptop
Language	English