Figure 46. Installing the optional IDSDM module
Next steps
1 Install the air shroud.
2 Follow the procedure listed in After working inside your system.
Related link
System board jumpers and connectors
Installing a drive carrier
Installing the air shroud
Removing the internal micro SD card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
Step
Locate the micro SD card slot on the internal dual SD module (IDSDM), and press the card to release it from the slot.
NOTE
: Temporarily label each micro SD card with its corresponding slot number before removal. Reinstall the micro SD
cards into the corresponding slots.
Next step
Install the internal micro SD card.
Installing and removing system components
91
To Next Page
Loading...
Need help?
General