Security Key and RAID Management 125
Delete Key
NOTE: Delete Key is active if there is a security key present on the controller.
NOTE: Delete Key can only be performed when there are no secured virtual disks
present.
NOTE: After the Delete Key operation, all unconfigured, secured SEDs shall be
secure-erased.
Perform the following steps when deleting the security key on the controller:
1
During host system bootup, press <Ctrl><R> when the BIOS screen is
displayed.
The
Virtual Disk Management
screen is displayed. If there is more than
one controller, the main menu screen is displayed.
2
Select a controller, and press <Enter>.
The
Virtual Disk Management
screen is displayed for the selected
controller.
3
Use the arrow keys to highlight
Security Key Management
.
4
Press <F2> to display the actions you can perform.
5
Select the
Delete key
and press <Enter>.
Creating Secured Virtual Disks
To create a secured virtual disk, the controller must have a security key
established first. See "Create Key" on page 122.
NOTE: Combining SAS and SATA hard drives within a virtual disk is not supported.
Also, combining hard drives and solid state drives (SSDs) within a virtual disk is not
supported.
After the security key is established, perform the steps outlined in the
"Creating Virtual Disks" on page 88 to create a virtual disk.
To secure the virtual disk, navigate to the Secure VD option at the bottom
left area of the Create New VD screen.
NOTE: All virtual disks added to a secured Disk Group are secured.
PERC7.2_UG.book Page 125 Thursday, March 3, 2011 2:14 PM
To Next Page
Loading...
Need help?
General
