Dell PowerEdge T610 User Manual

Troubleshooting Your System 157
If the problem persists, replace the device.
If all troubleshooting fails, see "Getting Help."
Troubleshooting a Serial I/O Device
1 Turn off the system and any peripheral devices connected to the serial
port.
2 Swap the serial interface cable with another working cable, and turn on the
system and the serial device.
If the problem is resolved, replace the interface cable.
3 Turn off the system and the serial device, and swap the device with a
comparable device.
4 Turn on the system and the serial device.
If the problem is resolved, replace the serial device.
If the problem persists, see "Getting Help."
Troubleshooting a NIC
1 Run the appropriate online diagnostic test. See "Using Dell™ PowerEdge™
Diagnostics."
2 Restart the system and check for any system messages pertaining to the
NIC controller.
3 Check the appropriate indicator on the NIC connector. See "Power
Indicator Codes."
• If the link indicator does not light, check all cable connections.
• If the activity indicator does not light, the network driver files might
be damaged or missing.
• Use another connector on the switch or hub.
If you are using a NIC card instead of an integrated NIC, see the
documentation for the NIC card.
4 Ensure that the appropriate drivers are installed and the protocols are
bound. See the NIC's documentation.
book.book Page 157 Tuesday, September 15, 2009 10:08 AM

Dell PowerEdge T610 Specifications

General

Brand	Dell
Model	PowerEdge T610
Category	Server
Language	English