164 Troubleshooting Your System
9
Check the memory channels and ensure that they are populated correctly.
See "General Memory Module Installation Guidelines."
10
Reseat the memory modules in their sockets. See "Installing Memory
Modules."
11
Replace the cooling shroud. See "Installing the Cooling Shroud."
12
Replace the expansion card stabilizer. See "Installing the Expansion Card
Stabilizer."
13
Close the system. See "Closing the System."
14
Place the system upright and on its feet on a flat and stable surface,
reconnect the system to the electrical outlet, and turn on the system and
attached peripherals.
15
As the system boots, observe any error messages or LCD messages that
appear.
16
Enter the System Setup program and check the system memory setting.
See "Memory Settings Screen."
If the problem is not resolved, proceed with the next step.
17
Turn off the system and attached peripherals, and disconnect the system
from the power source.
18
Open the system. See "Opening the System."
19
Remove the expansion card stabilizer. See "Removing the Expansion Card
Stabilizer."
20
Remove the cooling shroud. See "Removing the Cooling Shroud."
21
If a diagnostic test or error message indicated a specific memory module as
faulty, swap or replace the module.
22
To troubleshoot an unspecified faulty memory module, replace the
memory module in the first memory-module socket with a module of the
same type and capacity. See "Installing Memory Modules."
23
Replace the cooling shroud. See "Installing the Cooling Shroud."
24
Replace the expansion card stabilizer. See "Installing the Expansion Card
Stabilizer."
25
Close the system. See "Closing the System."
book.book Page 164 Tuesday, September 15, 2009 10:08 AM
To Next Page
Loading...
Need help?
General
