16
OPERATION
Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second is
sufficient to inflict serious personal injury.
Always wear eye protection with side shields and marked to comply with ANSI Z87.1. Failure to do so could
result in objects being thrown into your eyes, resulting in possible serious personal injury.
Do not use any attachments or accessories not recommended by the manufacturer of this tool. The use of
attachments or accessories not recommended can result in serious personal injury.
Before starting any cutting operation, clamp or bolt the compound miter saw to a workbench. Never operate
the miter saw on the floor or in a crouched position. Failure to heed this warning can result in serious
personal injury.
To avoid serious personal injury, always tighten the miter lock handle and bevel lock knob securely before
making a cut. Failure to do so could result in movement of the control arm or miter table while making a cut.
To avoid serious personal injury, keep hands outside the no hands zone, at least 3 in. from blade. Never
perform any cutting operation freehand (without holding workpiece against the fence). The blade could grab
the workpiece if it slips or twists.
When using a work clamp or C-clamp to secure the workpiece, clamp workpiece on one side of the
blade only. The workpiece must remain free on one side of the blade to prevent the blade from binding in
workpiece. The workpiece binding the blade will cause motor stalling and kickback. This situation could
cause an accident resulting in possible serious personal injury.
NEVER move the workpiece or make adjustment to any cutting angle while the saw is running and the blade
is rotating. Any slip can result in contact with the blade causing serious personal injury.
APPLICATIONS
You may use this tool for the following purposes:
Bevel cutting and compound cutting for crown moldings, etc.
Cross cutting wood and plastic
Cross cutting for moldings, door casings, picture frames, etc.
plastic, it is recommended that you use a specialty blade designed for these applications.
To Next Page
Loading...
Need help?
General
