parts when servicing your tool.
25.
clothing, gloves, neckties, rings, bracelets, or other
jewelry which may get caught in moving parts.
protective hair covering to contain long hair.
26.
in work area should wear safety glasses with side
shields. Everyday eyeglasses with impact resistant
lenses are not safety glasses. Eye equipment
27.
should wear proper hearing protection consistent
with noise levels and exposure. Hearing equipment
28.
generate and/or disburse dust, which may cause
serious and permanent respiratory or other injury,
including silicosis (a serious lung disease), cancer,
and death. Direct articles away from face and body.
Always operate tool in well-ventilated area and
provide for proper dust removal. Use dust collection
system whenever possible. Avoid breathing dust
and avoid prolonged contact with dust. Allowing
dust to get into your mouth or eyes, or lay on your
skin may promote absorption of harmful material.
respiratory protection appropriate for the dust
exposure and wash exposed areas with soap and
water.
29. Replace the warning labels if they become
obscured or removed.
30. This machine is designed and intended for use by
properly trained and experienced personnel only.
If you are not familiar with the proper and safe
operation of this product, do not use until proper
training and knowledge have been obtained.
31. Avoid prolonged contact with dust from power
sanding, sawing, grinding, drilling, and other
construction activities. Wear protective clothing and
wash exposed areas with soap and water. Allowing
dust to get into your mouth, eyes, or lay on the skin
may promote absorption of harmful chemicals.
Use of this tool can generate and/or disperse
dust, which may cause serious and permanent
approved respiratory protection appropriate for the
dust exposure. Direct particles away from face and
body.
Failure to follow these rules may result in serious personal injury.
operating saw. Learning the saw’s proper applications, limitations, and specific potential hazards will greatly
minimize the possibility of accidents and injury. Make sure all users are familiar with its warnings and instructions
before using saw.
connections.
1.
workbench or table at approximately hip height.
The saw can tip over if the saw head is released
suddenly and the saw is not secured to a work
surface.
2.
reach underneath work or in blade cutting path with
your hands and fingers for any reason.
3.
cutting to minimize risk of blade pinching and
kickback.
4. USE A CLAMP to secure the workpiece when
possible.
5. with the blade touching
the workpiece. Allow motor to come up to full
speed before starting cut.
6.
PLACE more than one workpiece on the saw table
at a time.
7.
GENERAL POWER TOOL SAFETY RULES
4
CALIFORNIA PROPOSITION 65
MITER SAW SAFETY RULES
Some dust created by power sanding, sawing, grinding, drilling and other construction activities
contains chemicals known to the state of California to cause cancer, birth defects or other
reproductive harm. Some examples of these chemicals are:
Lead from lead-based paints,
Crystalline silica from bricks and cement and other masonry products, and
Arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to
these chemical: work in a well-ventilated area, and work with approved safety equipment, such as those dust masks
that are specially designed to filter out microscopic particles.
To Next Page
Loading...
Need help?
General
