Delta VFD110B43A User Manual

Chapter 5 Parameters_VFD-B Series
5-12
Revision 10/2005, BE13, SW V4.08
Parameter Explanation Settings
Factory
Setting
Customer
05-33
The Amplitude of Wobble
Vibration
0.00~400.00 Hz
0.00
05-34 Wobble Skip Frequency 0.00~400.00 Hz 0.00
Group 6 Protection Parameters
Parameter Explanation Settings
Factory
Setting
230V series: 330.0V to 410.0V 390.0V
460V series: 660.0V to 820.0V 780.0V
575V series: 825.0V to1025.0V 975.0V
06-00 Over-Voltage Stall Prevention
00: Disable over-voltage stall prevention
06-01
Over-Current Stall Prevention
during Accel
20 to 250% 170
06-02
Over-Current Stall Prevention
during Operation
20 to 250% 170
00: Disabled
01: Enabled during constant speed
operation. After the over-torque is
detected, keep running until OL1 or OL
occurs.
02: Enabled during constant speed
operation. After the over-torque is
detected, stop running.
03: Enabled during accel. After the over-
torque is detected, keep running until
OL1 or OL occurs.
06-03
Over-Torque Detection Mode
(OL2)
04: Enabled during accel. After the over-
torque is detected, stop running.
00
06-04 Over-Torque Detection Level 10 to 200% 150
06-05 Over-Torque Detection Time 0.1 to 60.0 sec 0.1
00: Standard motor (self cooled by fan)
01: Special motor (forced external cooling)
06-06
Electronic Thermal Overload
Relay Selection
02: Disabled
02
06-07 Electronic Thermal Characteristic 30 to 600 sec 60
00: No fault
01: Over current (oc)
02: Over voltage (ov)
03: Over heat (oH)
04: Over load (oL)
06-08 Present Fault Record
05: Over load (oL1)
00

Delta VFD110B43A Specifications

General

Brand	Delta
Model	VFD110B43A
Category	DC Drives
Language	English