ENGLISH
ENGLISH
21
Basic Operation Basic Operation
4
Turn the SELECT knob, and press the CURSOR
FF
or
GG
button to select the optimum mode for
the source.
When the “SB CH OUT” parameter is set to “ON”. (Set “S.
BACK” at system setup to “SMALL” or “LARGE”.)
Display
(Pro Logic IIx Cinema mode)
(Pro Logic
IIx Music mode)
(Pro Logic
IIx Game mode)
When the “SB CH OUT” parameter is set to “OFF”. (Set
“S. BACK” at system setup to “NONE”.)
Display
(Pro Logic II Cinema mode)
(Pro Logic
II Music mode)
(Pro Logic II Game mode)
(Dolby Pro Logic mode)
Playing audio sources (CDs and DVDs)
2-channel playback modes
• The AVR-1906 is equipped with 2-channel playback modes
exclusively for music.
• Select the mode to suit your tastes.
Press the DIRECT/STEREO button on the main unit
or the DIRECT button on the remote control unit to
select the DIRECT mode.
2 DIRECT mode
Use this mode to achieve good quality 2-channel sound while
watching images. In this mode, the audio signals bypass such
circuits as the tone circuit and are transmitted directly, resulting
in good quality sound.
Press the DIRECT/STEREO button on the main unit
or the STEREO button on the remote control unit to
select the STEREO mode.
2 STEREO mode
Use this mode to adjust the tone and achieve the desired sound
while watching images.
Surround
Dolby Pro Logic
II
x (Pro Logic
II
) mode
•To play in the PLIIx mode, set “S. BackSp” at the “Speaker
Configuration” setting to “1sp” or “2sp”.
•To play in the PLIIx mode, set “Surround Back” at the “Power
Amp Assign.” setting.
1
Press the STANDARD button to select the Dolby
Pro Logic IIx mode.
• The Dolby Pro Logic II indicator lights.
Lights
2
Play a program source.
For operating instructions, refer to the manuals of the
respective components.
The mode switches as shown below each time the
STANDARD button is pressed.
3
Press the SURROUND PARAMETER button to
select the surround parameter mode.
See “Surround parameters q” for a description of the various
parameters.
5
Press the SURROUND PARAMETER button, and
press the CURSOR
DD
or
HH
button to select the
various parameters.
To Next Page
Loading...
Need help?
Power Amplifier Section
