Denon AVR-1911 User Manual

20
ENGLISH
Playback (Basic operation)
n Playing a Blu-ray Disc player/DVD player
(vpage21)
n Playing a CD player (vpage21)
n Playing an iPod
®
(vpage21)
n Tuning in radio stations (vpage24)
n Playing a USB memory device (vpage27)
Selecting a listening mode (Surround mode)
(vpage28)
n Selecting the input source (vpage20)
n Adjusting the master volume (vpage20)
n Turning off the sound temporarily (vpage20)
Playback (Advanced operation) (vpage36)
Important information
Before starting playback, make the connections between the different
components and the settings on the receiver.
NOTE
Also refer to the operating instructions of the connected components
when playing them.
Selecting the input source
Press the input source select button
(NET/USB, iPod, DVD, BD, TUNER,
DOCK, SAT/CBL, GAME, V.AUX, CD,
TV) to be played back.
The desired input source can be selected
directly.
• When iPod PLAY is pressed, the input
source of this unit is switched to “DOCK”
or “USB/iPod” and the connected iPod is
automatically played (vpage23 “iPod play
function”).
You can also use the following operation to select an input
source.
n Using the “Source Select” menu
q Press SOURCE SELECT.
Display the “Source Select” menu.
BD
CD
DVD
TV
GAME
SAT/CBL
V.AUX
DOCK
TUNER
Source Select
[ENT]:Select
[ ]:Source
The currently selected input source
is highlighted.
w Use uio p to select the input source,
then press ENTER.
The input source is set and the source
selection menu is turned off.
• When using with an iPod connected directly to the USB port of this
unit, select “USB/iPod” for the input source.
• Input sources that are not going to be used can be set ahead of time.
Make this setting at “Source Delete” (vpage59).
• To turn off the source selection menu without selecting an input
source, press SOURCE SELECT again.
n Using the knob on the main unit
Turn SOURCE SELECT.
• Turning SOURCE SELECT switches
the input source, as shown below.
BD DVD TV SAT/CBL GAME
V.AUXUSB/iPod DOCKTUNERCD
Adjusting the master volume
Use VOL df to adjust the volume.
n When the “Volume Display” setting
(vpage59) is “Relative”
GAdjustable rangeH
– – –
–80.5dB – 18.0dB
n When the “Volume Display” setting (vpage59) is
“Absolute”
GAdjustable rangeH
0.0 – 99.0
• The variable range differs according to the input signal and channel
level setting.
You can also operate via the main unit.
In this case, perform the following
operations.
Turn MASTER VOLUME to adjust the
volume.
Turning off the sound temporarily
Press MUTE.
• The sound is reduced to the level set at “Mute Level” (vpage59).
• To cancel, press MUTE again. Muting can also be canceled by
adjusting the master volume.

Denon AVR-1911 Specifications

General

Frequency range	10 - 100000 Hz
Audio output channels	7.1 channels
Audio A/D Converter (ADC)	24-bit/96kHz
Signal-to-Noise Ratio (SNR)	100 dB
Total Harmonic Distortion (THD)	0.8 %
HDMI	Yes
Audio system	Dolby TrueHD, Dolby Digital Plus, Dolby Digital EX, Dolby Pro Logic II, Dolby Pro Logic IIx, Dolby Pro Logic IIz, DTS-HD, DTS 96/24
Output power	125 W
Dimensions (WxDxH)	434 x 381 x 171 mm
Power requirements	AC 230, 50 Hz
HDMI ports quantity	5
AM band range	522 - 1611 kHz
FM band range	87.5 - 108 MHz
I/O ports	1 x Component in 1 x Composite Monitor out 1 x USB 1 x Microphone 1 x FM Tuner Antenna 1 x AM Tuner Antenna
Connectivity technology	Wired
Headphone outputs	7
Digital audio optical in	1
Product color	Black
Power consumption (standby)	0.1 W
Power consumption (typical)	460 W

Weight and Dimensions

Weight	10200 g