30
ENGLISH
DENON original surround playback
1
Playing the source (vpage 21 –
27).
2
Press SIMULATION to select the
surround mode.
• Each time SIMULATION is pressed, the
surround mode is switched.
MULTI CH
STEREO
This mode is for enjoying stereo sound from all
speakers.
ROCK ARENA
This mode is for enjoying the atmosphere of a live
concert in an arena.
JAZZ CLUB
This mode is for enjoying the atmosphere of a live
concert in a jazz club.
MONO MOVIE
z
This mode is for playing monaural movie sources
with surround sound.
VIDEO GAME
This mode is suited for achieving surround sound
with video games.
MATRIX
This mode lets you add a spacious feel to stereo
music sources.
VIRTUAL
This mode is for enjoying surround effects using
only the front speakers or headphones.
z When playing sources recorded in monaural in the “MONO
MOVIE” mode, the sound will be off balance with a single
channel (left or right), so input to both channels.
Depending on the program source being played, it may not be possible
to achieve a satisfactory surround effect. In this case, try other modes
to achieve a sound field suited to your tastes.
NOTE
When the input signal is Dolby TrueHD, Dolby Digital Plus, DTS-HD
or DTS Express, you cannot select DENON original surround mode.
Stereo playback
This is the mode for playing in stereo. The tone can be adjusted.
• Sound is output from the front left and right speakers and subwoofer.
• If multichannel signals are input, they are mixed down to 2-channel
audio and are played.
1
Playing the source (vpage 21 –
27).
2
Press D/ST to select “STEREO”.
Stereo playback begins.
Direct playback
Sound recorded in source is played as is.
• Surround back signals or front height signals are not created.
• In this mode, the following items cannot be adjusted.
• Tone (vpage51) • MultEQ
®
(vpage51)
• Dynamic EQ
®
(vpage52) • Dynamic Volume™ (vpage52)
• RESTORER (vpage53)
1
Playing the source (vpage 21 –
27).
2
Press D/ST to select “DIRECT”.
Direct playback begins.
If a “Small” speaker is used, playback in “Standard playback” mode
is recommended.
Pure direct playback
This mode is for playback in higher sound quality than in “Direct
playback” mode.
• The following circuits that affect sound quality are set to off.
• Main unit’s display circuit (The display is turned off.)
• Analog video input/output circuit
• Surround back signals or front height signals are not created.
• In this mode, the following items cannot be adjusted.
• Tone (vpage51) • MultEQ
®
(vpage51)
• Dynamic EQ
®
(vpage52) • Dynamic Volume™ (vpage52)
• RESTORER (vpage53)
1
Playing the source (vpage 21 –
27).
2
Press PURE.
The display goes dark, and pure direct
playback begins.
• To cancel, press PURE again.
• Video signals are only output when HDMI signals are played in the
PURE DIRECT mode.
• If
PURE DIRECT on the main
unit is pressed, the same
function as with the remote
control unit can be obtained.
NOTE
When in the PURE DIRECT mode, the menu screen is not displayed.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
