Denon AVR-2112CI User Manual

129
Symptom Cause/Solution Page
Cannot login to
Pandora. (“Email
address” or
“Password” is
displayed.)
tLogin information is incorrect. Check if the “Email address” for
Pandora has been properly entered. Re-enter the “Password”.
(Password is not displayed.)
http://www.pandora.com/denon
39
GAirPlayH
Symptom Cause/Solution Page
The AirPlay icon
is not displayed
in iTunes or on the
iPhone/iPod touch/
iPad.
tThis unit and the computer or iPhone/iPod touch/iPad are not
connected to the same network (LAN). Connect the computer or
iPhone/iPod touch/iPad to the same network as this unit.
tiTunes or the iPhone/iPod touch/iPad do not have firmware that
supports AirPlay installed. Update to the latest firmware.
12
96
No sound. tThe volume in iTunes or on the iPhone/iPod touch/iPad is set to
the minimum setting. Adjust the volume to the optimum level.
tThis unit is not selected in the screen that is displayed when
iTunes or the iPhone/iPod touch/iPad is started. Start iTunes or
switch on the iPhone/iPod touch/iPad, click the AirPlay icon
in
the displayed screen, and select this unit.
–
64
GRemote Control UnitH
Symptom Cause/Solution Page
The set cannot be
operated with the
remote control unit.
tBatteries are worn out. Replace with new batteries.
tOperate the remote control unit within a distance of about
23 ft/7 m from this unit and at an angle of within 30°.
tRemove any obstacle between this unit and the remote control
unit.
tInsert the batteries in the proper direction, checking the q and
w marks.
tThe set’s remote control sensor is exposed to strong light (direct
sunlight, inverter type fluorescent bulb light, etc.). Move the set
to a place in which the remote control sensor will not be exposed
to strong light.
tThe ZONE SELECT setting is not correct. Press
ZONE SELECT to
select the zone to operate.
tThe operation mode does not match the settings of the device to
operate. Check the operation mode.
116
116
116
116
116
105
105
Resetting the microprocessor
Perform this procedure if the display is abnormal or if operations cannot be performed.
When the microprocessor is reset, all the settings are reset to their default values.
ON/STANDBY
PRESET CHANNEL 3
PRESET CHANNEL 2
1
Turn off the power using ON/STANDBY.
2
Press ON/STANDBY while simultaneously pressing PRESET CHANNEL 2 and
PRESET CHANNEL 3.
3
<    @   '  J    +
buttons.
If in step 3 the display does not flash at intervals of about 1 second, start over from step 1.
Basic version Advanced version InformationInformation

Denon AVR-2112CI Specifications

General

Brand	Denon
Model	AVR-2112CI
Category	Receiver
Language	English