Denon AVR-2112CI User Manual

19
Error messages
NOTE
tAn error message is displayed if Audyssey
®
Auto Setup could not be completed due to speaker placement, the measurement environment, etc. If this happens, check the relevant items, be sure to take the necessary
measures, then perform Audyssey
®
Auto Setup over again.
tIf the result still differs from the actual connection status after remeasurement or the error message still appears, it is possible that the speakers are not connected properly. Turn this unit off, check the speaker
connections and repeat the measurement process from the beginning.
tBe sure to turn off the power before checking speaker connections.
Examples Error details Measures
MultEQ XT
Caution!
Microphone or Speaker is none
Retry
Audyssey Auto Setup
tThe connected setup microphone is broken, or a device other than the
supplied setup microphone is connected.
tNot all speakers could be detected.
tThe front L speaker was not properly detected.
tConnect the included setup microphone to the SETUP MIC jack of this unit.
tCheck the speaker connections.
MultEQ XT
Caution!
Ambient noise is too high or level is too low
Retry
Audyssey Auto Setup
tThere is too much noise in the room for accurate measurements to be
made.
tSpeaker or subwoofer sound is too low for accurate measurements to be
made.
tEither turn off any device generating noise or move it away.
tPerform again when the surroundings are quieter.
tCheck the speaker installation and the direction in which the speakers are
facing.
tAdjust the subwoofer’s volume.
MultEQ XT
Audyssey Auto Setup
Caution! Speaker:None
Front R
Retry
tThe displayed speaker could not be detected.
(The screen on the left indicates that the front right speaker cannot be
detected.)
tCheck the connections of the displayed speaker.
MultEQ XT
Audyssey Auto Setup
Caution! Speaker:Phase
Front R
Skip
Retry
tThe displayed speaker is connected with the polarity reversed.
(The screen on the left indicates that the polarity phases of the front right
speakers are reversed.)
tCheck the polarity of the displayed speaker.
tFor some speakers, this error message may be
displayed even if the speaker is properly connected.
If you are sure the connection is correct, press
ui
to select “Skip”, then press
ENTER.
Set up speakers (Audyssey
®
Auto Setup)
Basic version Advanced version InformationBasic version

Denon AVR-2112CI Specifications

General

Brand	Denon
Model	AVR-2112CI
Category	Receiver
Language	English