Denon AVR-2112CI User Manual

11
Connecting an antenna
tConnect the FM antenna or AM loop antenna supplied with the unit
to enjoy listening to radio broadcasts.
tAfter connecting the antenna and receiving a broadcast signal
(
vpage 27 “Listening to FM/AM broadcasts”), fix the antenna
with tape in a position where the noise level becomes minimal.
weq
FM outdoor
antenna
Direction of broadcasting station
75 Ω coaxial
cable
Ground
AM outdoor
antenna
AM loop antenna
(supplied)
Black
White
FM indoor
antenna
(supplied)
nAM loop antenna assembly
1
Put the stand section
through the bottom of the
loop antenna from the
rear and bend it forward.
Stand
Square
hole
Projecting
part
Loop
antenna
2
Insert the projecting part
into the square hole in
the stand.
nUsing the AM loop antenna
Suspending on a wall
Suspend directly on a wall without assembling.
Nail, tack, etc.
Standing alone
Use the procedure shown above to assemble.
NOTE
tDo not connect two FM antennas simultaneously.
tEven if an external AM antenna is used, do not disconnect the AM
loop antenna.
tMake sure the AM loop antenna lead terminals do not touch metal
parts of the panel.
tIf the signal has noise interference, connect the ground terminal
(GND) to reduce noise.
tIf you are unable to receive a good broadcast signal, we recommend
installing an outdoor antenna. For details, inquire at the retail store
where you purchased the unit.
Connecting a CD player
tYou can enjoy CD sound.
tSelect the connector to use and connect the device.
Cables used for connections
Audio cable (sold separately)
Audio cable
R
L
R
L
R
L
R
L
AUDIO
AUDIO
RL
OUT
CD player
Set this to change the digital input connector to which the input
source is assigned.
“Input Assign” (
vpage101)
in Set as Necessary
Basic version Advanced version InformationBasic version

Denon AVR-2112CI Specifications

General

Brand	Denon
Model	AVR-2112CI
Category	Receiver
Language	English