Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting Specifications
NOTE
Keep the power cord unplugged until the XM Mini-Tuner and Home
Dock connection have been completed.
XM Connector
• The AVR-4308CI is an XM Ready
®
receiver. You can receive XM
®
Satellite Radio by connecting to the XM Mini-Tuner and Home Dock
(includes home antenna, each sold separately) and subscribing to the
XM service.
• Plug the XM Mini-Tuner and Home Dock into the XM connector on
the rear panel.
• Position the Home Dock antenna near a south-facing window to
receive the best signal.
For details, see “Listening to XM Satellite Radio Programs” (vpage
51, 52).
When making connections, also refer to the operating instructions of
the XM Mini-Tuner and Home Dock.
XM Mini-Tuner and Home Dock
• The XM name and related logo are registered trademarks of XM
Satellite Radio Inc. All rights reserved.
• XM Ready is a registered trademark of XM Satellite Radio Inc. All
rights reserved.
Connections
USB Port
• In the initial status, USB memory devices can be used by connecting them to the USB port on the front panel.
• To change the port to be used, see “USB Select” on page 42.
• For instructions on playing the files on a USB memory device, see page 58, 59.
NOTE
• Set to the USB port you want to use.
• The AVR-4308CI is equipped with two USB ports, one each on the front and rear panels. It is not possible to use the set with USB memory
devices connected to both the ports at the same time. Select the USB port you want to use at the “Source Select” – “NET/USB” – “Playback
Mode” – “USB Select” menu.
• Do not use the extension cable for connecting the USB memory deveice to the AVR-4308CI’s USB port.
Use of the extension cable may cause harmful interference.
n Front panel n Rear panel
USB memory device USB memory device
To Next Page
Loading...
Need help?
General
