Denon AVR 4308CI - AV Network Receiver User Manual

0
Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting SpecificationsPlayback
Presetting Radio Stations
(Preset Memory)
Your favorite broadcast stations can be preset so that you
can tune them in easily. Up to 56 stations can be preset.
1
Tune in the broadcast station you want to preset.
2
Press [MEMO].
3
Press [A ~ G] to select the block in which the station is
to be preset, then press [CHANNEL] or [1 ~ 8] to select
the preset number.
b The memory block can also be selected by pressing [SHIFT].
4
Press [MEMO] again to complete the setting.
Press <TUNING PRESET>, then turn <SOURCE SELECT>
to select the preset radio station.
• To preset other stations, repeat steps 1 to 4.
• Stations can be preset automatically at GUI menu “Source Select”
– “Tuner” – “Auto Preset” (vpage 40).
NOTE
Preset stations are erased by overwriting them.
Listening to Preset Stations
Operation on the Main Unit
Operation on the Main Remote Control Unit
1
Either turn <SOURCE SELECT> or press [TUNER]
(AMP mode) to select “TUNER”.
: ”Source Select” (vpage 39, 40)
2
To operate using the main remote control unit, set
the remote control unit to the TUNER (DEVICE1)
mode.
(vpage 64 “Remote Control Unit Operations”)
3
Press [BAND] to select “FM” or “AM”.
4
Tune in the desired broadcast station.
q To tune in automatically (Auto Tuning)
Press [MODE] to light the “AUTO” indicator on the display, then use
[df] to select the station you want to hear.
w To tune in manually (Manual Tuning)
Press [MODE] to turn off the display’s “AUTO” indicator, then use
[df] to select the station you want to hear.
Listening to FM/AM Broadcasts
• It is also possible to switch to “FM” or “AM” in step 1 by pressing
[TUNER].
• If the desired station cannot be tuned in with auto tuning, tune it in
manually.
• When tuning in stations manually, press and hold [df] to change
frequencies continuously.
• The time for which the GUI menus are displayed can be set at GUI
menu “Manual Setup” – “Option Setup” – “GUI” – “Tuner” (vpage
37).
Basic Operation
n Recalling preset stations from the remote control
unit
1
Press [A ~ G] to select the memory block.
2
Press [CHANNEL] or [1 ~ 8] to select the desired preset
channel.
n Default settings
Auto tuner presets
A1 ~ A8
87.5 / 89.1 / 98.1 / 107.9 / 90.1 / 90.1 / 90.1 /
90.1 MHz
B1 ~ B8
520 / 600 / 1000 / 1400 / 1500 / 1710 kHz,
90.1 / 90.1 MHz
C1 ~ C8
90.1 MHz
D1 ~ D8
90.1 MHz
E1 ~ E8
90.1 MHz
F1 ~ F8
90.1 MHz
G1 ~ G8
90.1 MHz

Denon AVR 4308CI - AV Network Receiver Specifications

General

Brand	Denon
Model	AVR 4308CI - AV Network Receiver
Category	Stereo Receiver
Language	English