Denon AVR 4308CI - AV Network Receiver User Manual


Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting Specifications
g
Manual EQ
Adjust tonal quality for each speaker using graphic
equalizer.
Adjust CH
Select speaker adjustment method.
[Selectable items] Each L/R All
Manual EQ
Select the speaker and frequency band and adjust the level.
[Selectable items] 63 125 250 500 1k 2k 4k
8k 16k
Curve Copy
Copy “Audyssey Flat” curve from Room EQ.
[Selectable items] Yes No
“Curve Copy” is displayed after the auto setup procedure has been
performed.
Default
Resets the settings to the default values.
[Variable range]
–20dB
~
0dB
~
+6dB
Setup
1
Connect the LAN cable (vpage 20).
2
Turn on the AVR-4308CI (vpage 49).
AVR-4308CI performs automatic network setup due to the DHCP
function.
When connecting to a network that has no DHCP function,
perform the setting in step 3.
3
Set the IP address at the GUI menu “Manual Setup”
“Network Setup” – “Network Setup”.
q Select “Detail” and press the ENTER button.
w
Use the o p button to set “DHCP” to “OFF”, then press the i
button.
The DHCP function is disabled.
Network Setup
Make network settings.
F Menu tree F
Manual Setup
Network Setup
a Network Setup
s Other
d Network Information
a Network Setup
Make settings for wired or wireless LAN.
Wired LAN settings
Use this procedure to configure the Wired LAN settings.
• DHCP (Dynamic Host Configuration Protocol) :
These are systems by which the IP address and other network
settings are automatically set for the AVR-4308CI, computer,
broadband router and network devices.
• DNS (Domain Name System) :
This is a system for converting the domain names used when
browsing Internet sites (for example, “www.denon.jp”) into the
IP addresses actually used for communications (for example,
“202.221.192.106”).
q Select “Detail”.
e Input the address.
r Select “Exit”.
w Set “OFF”.
• If you are using a broadband router (DHCP function), there is no need
to make the settings at “Setting the IP Address” and “Setting the
Proxy”, since the DHCP function is set to “ON” in the AVR-4308CI’s
default settings.
• If the AVR-4308CI is being used connected to a network without
the DHCP function, the network settings must be made. In this
case, some knowledge of networks is required. For details, consult
a network administrator.
• If you cannot connect to the Internet, recheck the connections and
settings (vpage 20).
• If you do not understand about Internet connection, contact your ISP
(Internet Service Provider) or the store from which you purchased
your computer.

Denon AVR 4308CI - AV Network Receiver Specifications

General

Brand	Denon
Model	AVR 4308CI - AV Network Receiver
Category	Stereo Receiver
Language	English