Listening to FM/AM broadcasts
1
Connect the antenna. (“Connecting an FM/AM
antenna” (v
p. 48))
2
Press TUNER to switch the input source to “Tuner”.
G TV screen H
.
Tuner
CH 1
FM 87.50MHz
Tune Preset Option
G Display of this unit H
.
3
Press OPTION.
The option menu screen is displayed.
4
Use ui to select “FM/AM”, then press ENTER.
This displays the reception band input screen.
5
Use o
p to select “FM” or “AM”, then press ENTER.
FM: When listening to an FM broadcast.
AM: When listening to an AM broadcast.
6
Press TUNE + or TUNE - to select the station you want
listen to.
Scanning is performed until it finds an available radio station. When
it finds a radio station, it stops the scan automatically and tunes in.
The modes for receiving FM broadcasts consists of “Auto” mode that automatically
searches available broadcast stations and “Manual” mode that lets you tune in using
buttons to change the frequency. The default setting is “Auto”. You can also use
“Direct Tune” to tune in by entering the frequency directly.
In “Auto” mode, you cannot tune in to radio stations if the reception is not good.
If this is the case, then use the “Manual” mode or “Direct Tune” mode to tune in.
Operation buttons Function
TUNE +, – Selects the radio station (up/down)
CHANNEL +, - Selects preset radio stations
Contents Connections Playback Settings Tips Appendix
70
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
Weight and Dimensions
