(
2)
Pitch Bending
The BPM increases or decreases temporarily while the PITCH BEND + or PITCH BEND - button is pressed.
The extent to which the PITCH BEND button changes the BPM is proportionate to the amount of time the button is pressed.
The longer the button is held down, the greater the percentage of change.
The PITCH BEND button changes the BPM within a range of ± 12% when the pitch adjustment range is ±
4%
or ±
8% ,
and within a range of
±
1
8% when the pitch adjustment range is ± 16%.
Figure 16 shows an example of how to use the pitch bend function. In this example, both players are playing and the BPM
has already been matched with the pitch sliders.
The CD1 and CD2 BPMs are matched
but the bass beats are off.
The bass beats also match.
Figure 16
SEAMLESS LOOP
The DN-2500F is equipped with a seamless loop function.
NOTE:
The seamless loop mode cannot be used at the same time as the sampler mode.
(1)
Starting seamless loop playback
Press the LOOP button to enter the seamless loop mode.
(
The LOOP button's LED flashes.)
Press the A button to set the starting point (A).
(
The A button's LED lights.)
Press the B button to set the ending point (B).
(
The B button's LED lights and the LOOP button's LED stops flashing, re-
maining lit.)
Press the PLAY/PAUSE button.
(
The PLAY/PAUSE button's LED lights.)
(
continued on next page)
1
7
To Next Page
Loading...
Need help?
Power
Operating Environment
Weight and Dimensions
