13
Remove all wastes and impurities from the machine. Ensure that there is no oil contaminated
rags or other flammables on the machine.
Handle all solvents and dry chemicals (Foam fire extinguisher) as per the manufacturer’s
procedures indicated on the container. Operate in a well-ventilated place. Never use fuel for
cleaning purpose.
Always use non-flammable solvent. Please ensure thorough ventilation during the handling of
fuel and the cleaning of oil stain or paint. Preserve all flammable liquids and materials in a safe
and well-ventilated place.
The short-circuit of the electrical system may result in fire. Check the wire connections daily for
looseness and damage. Re-tighten loose connectors and cable clamps. Repair or replace
damaged wires.
Fire accident caused by pipelines: Ensure that the clamps, protection devices, and cushion pads
of hoses and pipes are securely fixed. If loose, the hoses and pipes will be damaged due to
vibration or contact with other parts during operations. This may result in spraying of high-
pressure oil to cause fire accident or harm.
Toxic Exhaust Gas from Engine
Do not operate the engine in an enclosed place with poor ventilation. If natural ventilation is not
possible, install ventilation fan, fan, extended
exhaust pipe, or other ventilation device.
Handling of Asbestos Powders
The inhalation of asbestos powders may
cause lung cancer. While handling materials
that may contain asbestos, take the following
safety measures:
Do not sweep with compressed air.
Avoid polishing or grinding asbestos-
contained parts.
During cleaning, use a vacuum device installed with high-efficiency particulate air filter (HEPA).
If there is no other method for control of powders, please wear the specified respirator. During
indoor operations, please install a ventilation system with polymer filter.
To Next Page
Loading...
Need help?
General