Digi Connect and ConnectPort TS Family command-line interface Administration
Digi Connect Family and ConnectPort TS Family
123
Administrative task Command
Update firmware boot
To update the firmware:
1. Telnet to the Digi device command-line interface
using a telnet application or hyperterm.
2. If security is enabled for the Digi device, a login
prompt appears. The default user name is root and
the default password is dbps. If these defaults do
not work, contact the system administrator who
set up the device.
3. If you are at the bash shell, type configshell to get
to the config shell.
4. Issue the boot load command:
#> boot load=
tftp-server-ip
:
filename
Replace tftp-server-ip with the IP address of the
TFTP server that contains the firmware, and
replace filename with the name of the file to upload.
Reset configuration to factory defaults revert
or
boot action=factory
Display system information and
statistics
info
Reboot the device boot
Enable/disable network services set service
To Next Page
Loading...
Need help?
General
