Digi Connect and ConnectPort TS Family web interface Configuration through the web interface
Digi Connect Family and ConnectPort TS Family
73
4. Configure the fields in the following sections:
n Alarm Conditions: These condition specify the conditions on which the alarm is based,
such as serial data pattern matching or data usage.
n Alarm Destinations: These conditions specify how the alarm is sent, either as an email
message or an SNMP trap, or both, and where the alarm is sent.
5. Click Apply to save your changes.
System Configuration
Use the System Configuration page to configure device identity and description information, date and
time settings, and settings for Simple Network Management Protocol (SNMP).
Device Identity Settings
Use the Device Identity Settings page to create a description of the Digi Connect and ConnectPort TS
Family product’s name, contact, and location. You can use this information to identify a specific Digi
device product when working with a large number of devices in multiple locations.
n Description: The network name assigned to the Digi device.
n Contact: The SNMP contact person (often the network administrator).
n Location: A text description of the physical location of the Digi device.
n Device ID: A text description of the device ID used to identify the device (for example, MAC or
IPaddress).
Simple Network Management Protocol (SNMP) Settings
Use the Simple Network Management Protocol (SNMP) Settings page to manage and monitor
network devices. You can configure Digi Connect and ConnectPort TS Family devices to use SNMP
features, or you can disable SNMP for security reasons. For additional information, see Simple
Network Management Protocol (SNMP).
n Enable Simple Network Management Protocol (SNMP): This check box enables or disables
use of SNMP.
l The Public community and Private community fields specify passwords required to get
or set SNMP-managed objects. Changing public and private community names from their
defaults is recommended to prevent unauthorized access to the device.
l Public community: The password required to get SNMP-managed objects. The default is
public.
l Private community: The password required to set SNMP-managed objects. The default is
private.
l Allow SNMP clients to set device settings through SNMP: This check box enables or
disables the capability for users to issue SNMP set commands uses use of SNMP read-only
for the Digi device.
To Next Page
Loading...
Need help?
General
