Digi Connect and ConnectPort TS Family web interface Configuration through the web interface
Digi Connect Family and ConnectPort TS Family
72
l Send reminders while GPIO pins remain in this state: If enabled, reminders will be sent
if the pins remain in the defined state for an extended period of time.
l Every: The number of seconds the pins must remain in the defined state for a reminder to
be sent.
n Send alarms based on serial data pattern matching: Click this radio button to specify that
this alarm is sent when the specified serial data pattern is detected. Then specify the following:
l Serial Port: The serial port to monitor for the data pattern. This field appears for devices
where more than one serial port is available.
l Pattern: When the serial port receives this data pattern it sends an alarm. You can include
special characters such as carriage return carriage return (\r) and new line (\n) in the data
pattern.
Alarm Destinations
Use the Alarm Destinations page to define how alarm notifications are sent, either as an email
message or an SNMP trap, or both, and where the alarm notification is sent.
n Send E-mail to the following recipients when alarm occurs: Enable sending the alarm as an
email message. Then specify the following information:
l To: The email address to which this alarm notification email message will be sent.
l CC: The email address to which a copy of this alarm notification email message will be sent
(optional).
l Priority: The priority of the alarm notification email message.
l Subject: The text to be included in the Subject: line of the alarm-notification email.
n Send SNMP trap to the following destination when alarm occurs: Specifies whether to
send the alarm as an SNMP trap. To send alarms as SNMP traps, you must set the Alarm Type
to snmptrap and specify the IP address of the destination for the SNMP traps in the SNMP
settings (Configuration > System > Simple Network Management Protocol). See Simple
Network Management Protocol (SNMP) Settings. That destination IP address appears below
the “Send alarm to SNMP destination” check box. You can also specify a secondary or backup
SNMP destination.
To configure an alarm notification to be sent as both an email message and an SNMP trap:
1. Select both Send E-Mail and Send SNMP trap check boxes.
2. Click Apply to apply changes to alarm settings and return to the Alarms Configuration page.
Configure alarm conditions
To configure an alarm:
1. Select Configuration > Alarms.
2. To enable or disable an alarm, select or clear the Enable check box next to the alarm.
3. Click the alarm under the Alarm column that you want to configure.
To Next Page
Loading...
Need help?
General
