Digi Connect and ConnectPort TS Family web interface Configuration through the web interface
Digi Connect Family and ConnectPort TS Family
71
n Mail Server Address (SMTP): Specifies the IP address of the SMTP mail server. Ask your
network administrator for this IP address.
n From: Specifies the text that used in the “From:” field for all alarms that are sent as emails.
Alarm list and status
The Alarm Conditions page lists all of the alarms. You can configure up to 32 alarms for a Digi device,
and you can individually enable and disable these alarms.
The alarm list displays the current status of each alarm. You can use this list to view alarm status at a
glance, then view more details for each alarm as needed.
n Enable: The check box indicates whether the alarm is currently enabled or disabled.
n Alarm: The number of the alarm.
n Status: The current status of the alarm, which is either enabled or disabled.
n Type: The basis for the alarm; whether it is based on GPIO pin state changes or serial data
pattern matching.
n Trigger: The conditions that trigger the alarm.
n SNMP Trap: Indicates whether the alarm is sent as an SNMP trap.
l If the SNMP Trap field is disabled, and the Send To field has a value, the alarm is sent as an
email message only.
l If the SNMP Trap field is enabled and the Send To field is blank, the alarm is sent as an
SNMP trap only.
l If the SNMP Trap field is enabled, and a value is specified in the Send To field, that means
the alarm is sent both as an email and as an SNMP trap.
n Send To: The email address to which the alarm is sent.
n Email Subject: Text to include in the Subject line of alarms sent as email messages.
Alarm Conditions
Use the Alarm Conditions page to specify the conditions on which the alarm is based, such as GPIO pin
state changes, serial data pattern matching, signal strength (RSSI), or data usage. Alarm conditions
include:
n Send alarms based on GPIO pin states: Click this radio button to specify that this alarm is
sent when the specified GPIO pin states are detected. Then specify the following:
l Pins: An alarm is sent when the specified combination of pin states is detected.
High - pin is asserted.
Low - pin is not asserted.
Ignore - pin state is ignored.
l Alarm recurrence time: Defines how often to send a new alarm. For example, if the alarm
recurrence time is 10 seconds then even if the pin states are detected 5 times within a 10
second period only one alarm will be sent.
To Next Page
Loading...
Need help?
General
