Digi One SP User Manual

Chapter 5
Administration
37
Resetting the Configuration to Defaults
Introduction
The two procedures in this section reset the configuration to
defaults. The first procedure resets the configuration from a
web browser. If you can access the device server from a web
browser, this is the best way to reset the configuration
because you can also back up the configuration, which
provides a means for restoring it after you have worked
through configuration issues. See "Copying the Configuration
to and from a Server" on page 39 for more information.
The second procedure resets the configuration using the
reset button on the device server. Use this method if you
cannot access the device from a web browser.
Resetting the Configuration from a Browser
1. Open a web browser and enter the device server’s IP
address in the URL window.
2. When the device server prompts you to log in, enter the
following:
• root as the user name
• The root password. The default is dbps.
3. Choose Admin > Reset Config from the main menu.
4. Follow the prompts to complete this procedure.
Resetting the Configuration Using the Reset Button
1. Power off the device server by unplugging the power.
2. Use a pen, the point of a paper clip, or some other pointed
object to press and hold down the reset button. The fol-
lowing figures help you locate the reset button. The first
shows a Digi One IA. The second a Digi One SP.

Digi One SP Specifications

General

Brand	Digi
Model	One SP
Category	Server
Language	English