1. Begin with the recorder stopped.
2. Press the SETUP button until the GNX3’s main display reads
tmpo=120.
3. Use the DATA WHEEL to adjust the tempo. By turning on the DRUMS button, you can hear the
change of the Drums tempo in the audio outputs.
4.When finished, press EXIT.
NOTE: Although the Tempo of a song can be changed after tracks have been recorded, it is
not advised that you do so because previously recorded tracks will not be
synchronized with tracks recorded after the change. The Recorder Tempo also
controls the Drum Machine tempo when recording or playing a virtual Drum track.
Pre-Roll
Pre-Roll is an amount of time you can have the recorder count off before actually beginning to recorder.
Use Click Track during Pre-Roll so that you can then get a feel for the tempo of the track or song you
are about to record. Pre-Roll can also be used as a cue, indicating when the very beginning of the song
starts. The GNX3’s Pre-Roll has 3 settings, 4, 8, or 16 counts. To setup the Pre-Roll function, follow these
steps:
1. Begin with the recorder stopped.
2. Press the SETUP button until the GNX3’s main display reads
pre-rollOf.
3. Use the DATA WHEEL to select the amount of Pre Roll or turn it off. You can select from 4, 8, or
16 counts before recording begins.
4.When finished, press EXIT.
To Next Page
Loading...
Need help?
General
