Quick Start
The Quick Start section is included for those of you who would rather play now and read later.
Making Connections
1. Connect your instrument to the INPUT jack on the rear panel.
2. Connect the LEFT/RIGHT OUTPUTS to the input(s) of your amplifier(s), power amp, or mixer.
Apply Power
1.Turn the OUTPUT level knob, on the rear panel of the GNX3, all the way down (fully counter
clockwise).
2. Connect the PSS3 power supply to the POWER jack on the GNX3.
3. Connect the other end of the PSS3 power supply to an AC outlet.
4.Turn the GNX3 POWER switch on.
5.Turn your amplifier(s) on, and adjust the volume(s) to a normal playing level. Gradually turn up the
GNX3’s OUTPUT level.
Select an Analog Output Mode
1. Press the UTILITY button.
2. Rotate the DATA WHEEL to select an output mode.
3. Select one of the following settings: mono, stereo, guitar(Left)/Recorder(Right), guitar mono, or guitar
stereo.
Select The Target System Setup
1. Select an Output (see Select an Output Mode above).
2. Press the DRUMS button. The Target System Setup menu is displayed.
3. Rotate the DATA WHEEL to select an amplification system.
4. Press EXIT.
Select a Preset
The GNX3 comes with 65 pre-programmed Factory Presets, and 65 User Presets. From the factory, the
User Presets are exact duplicates of the Factory Presets.
1. Press the UP/DOWN footswitches to select a Bank.
2. Press Footswitches 1-5 to select a preset, or rotate the DATA WHEEL.
Note: To edit a preset, see page 14.
2
Introduction
To Next Page
Loading...
Need help?
General
