gatthres (Noise Gate Threshold) - Controls the Noise Gate’s Threshold.
gatattak (Noise Gate Attack) - Controls the Noise Gate’s Attack time.
PLK SENS (Noise Gate Pluck) - Controls the Noise Gate’s Pluck Sensitivity.
fx onoff (Chorus/Mod On/Off) - Turns the Chorus/Mod module on and off.
Modulation Effects Parameters
Active Effect
Chorus
Speed Depth predly MOD Bal MOD LVL
Flanger Speed Depth Regen MOD Bal MOD MIX
Phaser Speed Depth Regen MOD Bal MOD MIX
Tr i ggered Flanger Speed Senstvty LFO St MOD MIX
Tr iggered Phaser Speed Senstvty LFO St MOD MIX
Tremolo Speed Depth
Panner Speed Depth
Vibrato Speed Depth
Rotary Speaker Speed Depth Doppler crosover MOD BAL MOD MIX
Auto Ya™ Speed Depth RANGE MOD Bal MOD MIX
Ya Ya™ YA PDL Depth RANGE MOD Bal MOD MIX
SynthTalk Attack Release Vox MOD Bal Senstvty
Envelope Filter Senstvty Range MOD Bal MOD MIX
Detune Amount MOD Bal MOD LVL
Pitch Shift SHIFT MOD Bal MOD LVL
dly onoff
(Delay On/Off) - Turns the Delay module on and off.
DLY fdbk (Delay Feedback) - Controls the amount of Delay Feedback.
dukthres (Delay Threshold) - Controls the Ducker Threshold for the Delay.
duk attn (Ducker Attenuation) - Controls the attenuation level applied to the Delay signal when the
Ducker Threshold is exceeded.
DLY lvl (Delay Level) - Controls the Mix Level of the selected Delay Type.
DLY BAL (Delay Balance) - Controls the left/right balance of the selected Delay Type.
rvbonoff (Reverb On/Off) - Turns the Reverb effect on and off.
RVB PRE (Reverb Predelay) - Controls the Reverbs Predelay time.
rvbdecay (Reverb Decay) - Controls the Reverbs Decay time.
RVB lvl (Reverb Level) - Controls the Reverbs Mix Level.
RVB BAL (Reverb Balance) - Controls the left/right balance of the selected Reverb Type.
VOL PRE (Volume Pre) - Controls the Volume after the Amp Modeling but before the Effects.
VOL PoST (Volume Post) - Controls the Volume at the end of the Effects chain.
LFo1 SPD (LFO 1 Speed) - Controls the modulation speed of Expression LFO 1.
LFo2 SPD (LFO 2 Speed) - Controls the modulation speed of Expression LFO 2.
Utilities
The Utility section contains all of the menus for assigning global functions to the GNX3. Global functions
affect the GNX3 in its entirety rather than on a per preset basis.The Utility menus include: Mono/Stereo
Output,Target System Setup,Volume Pedal Update,V-Switch Threshold, Expression Pedal Calibration, Dry
Track Enable, Bank Naming, MIDI Channel, MIDI Sysex Dumps,Amp Dumps, MIDI Mapping, MIDI Merge, and
Factory Reset.To enter the Utility section, press the Utility button. Once in the Utility menu, the Drums
button selects the next menu (scrolls to the right), and the Mode button selects the previous menu (scrolls
to the left). Each of these Utility menus is described in more detail in the following pages.
65
Other Functions
To Next Page
Loading...
Need help?
General
