DigiTech GNX3 User Manual

5. Press STORE.The Display reads SeND TO.
6. Use the DATA WHEEL to select the destination preset number.
7. Set the MIDI recording device to record.
8.Press STORE again.The display reads
send pst until the dump is complete at which time the display
briefly reads
DONE before it returns to PrSTDuMP.
9. Press EXIT to return to the GNX3 presets.
The Preset Dump sends information on the MIDI channel defined in the MIDI Channel menu.
NOTE:The Preset Dump sends information on the MIDI channel defined in the MIDI Channel menu.
User Amp Dump
User Amp Dump uploads the GNX3 Amp HyperModels™ to a sysex librarian, or MIDI recording device.
This is useful for making a backup copy of your customized Amp HyperModels™, and copying your
HyperModels™ into another GNX3. The procedure for performing a User Amp Dump is as follows:
1. Connect a MIDI cable from the GNX3 MIDI Out to the the MIDI In of a MIDI recording device or the
MIDI in of another GNX3.
2. Press the UTILITY button.The Utility button’s LED lights.
3. Using the MODE or DRUMS button, scroll to the left or right until
AMP DuMP (Amp Dump) is
displayed.
4. Use the DATA WHEEL to select the Amp number you want to dump.
5. Press STORE.The display reads
SND TO.
6. Use the DATA WHEEL to select the destination User Amp number.
7. Set the MIDI recording device to record.
8. Press STORE again.The display reads
send amp until the dump is complete at which time the display
briefly reads
DONE before it displays AMP DuMP.
9. Press EXIT to return to the GNX3 presets.
NOTE:The Amp Dump sends information on the MIDI channel defined in the MIDI Channel menu.
MIDI Mapping
MIDI Mapping provides access to all factory and user presets from external MIDI program change
commands that may not correspond to the GNX3 preset. This is useful when multiple MIDI devices are
chained together and controlled by one central unit. For example, the main MIDI controller can send out
a program change command telling a particular MIDI unit to change to Program 10, but you may want the
GNX3 to change to User Preset 27. You can remap the GNX3 so when it receives MIDI Program change
10, it calls up User Preset 27. The Procedure for mapping MIDI program changes is as follows:
1. Press the UTILITY button.The Utility button’s LED lights.
2. Using the MODE or DRUMS buttons, scroll to the left or right until
M 1>U.is displayed.
3. Use the DATA WHEEL to select the incoming MIDI program number you want to remap. Notice
the flashing number to the right of the
M increases and decreases as you turn the Data Wheel.
4. Press the DRUMS button. Notice the number in the red numeric display begins flashing. This number
represents the GNX3 preset number that is accessed when the GNX3 receives the MIDI program
number shown to the right of the
M in the alpha-numeric display.
5. Rotate the DATA WHEEL to select the preset number the GNX3 will use when it receives the
selected MIDI program change.
6. Press EXIT to return to the GNX3 presets.
69
Other Functions

DigiTech GNX3 Specifications

General

Brand	DigiTech
Model	GNX3
Category	Music Pedal
Language	English