About the RP100 Artist
The Presets
Presets are numbered locations of programmed sounds which reside in the RP100 Artist. Presets
are recalled with the Footswitches.The active effects in each Preset will be indicated by the
lighted LEDs in the Effect Matrix.The RP100 Artist comes with 40 User Presets (Presets 1U-
40U), 40 Factory Presets (Presets 41F-80F), and 40 Artist Presets (Presets 81A-120A).The User
Presets are locations where your creations may be stored.The Factory Presets and Artist Presets
will not allow you to store any changes to them.The 40 User Presets are exact duplicates of the
40 Artist Presets.This allows you to create your own Presets without the worry of losing any of
the sounds that the RP100 Artist came with.
Performance Mode
When you first apply power to the RP100 Artist, it will power up in Performance mode.
Performance mode provides access to all of the Presets within the RP100 Artist via the Right
and Left Footswitches.The Parameter 1 (left) knob will adjust the Amp Gain (distortion), the
Parameter 2 (middle) knob will select the Amp Type, and the Parameter 3 (right) knob will
adjust the Master Level (volume).
Bypass Mode
The RP100 Artist Presets can be bypassed for a clean, unprocessed guitar tone.To bypass the
RP100 Artist, press both Footswitches simultaneously.The Display will read By indicating the
Preset is bypassed. Pressing both Footswitches simultaneously again will exit Bypass and return
the RP100 Artist to the last Preset used.
10
To Next Page
Loading...
Need help?
General
