Detune (dt)
A Detuner will make a copy of your incoming signal, take the copied signal slightly out of tune
from the original, and mix the two signals together.The result is a doubling type of effect as if
two guitars were playing the same part together.
Amount - The Parameter 1 knob adjusts the amount of pitch difference applied to the copied
signal. Ranges from -12 to 12.
Level - The Parameter 2 knob controls the mix of the detuned note. Ranges from 0 to 99.
Whammy™ (bd)
Whammy™ is an effect that uses an Expression Pedal to bend the pitch of the
incoming signal, or add a bendable harmony with the original signal. As the Pedal
is moved, the note will bend either up or down.
Amount - The Parameter 1 knob selects the interval and direction of the pitch bend.
Level - The Parameter 2 knob adjusts the volume of the Whammy™. Ranges from 0 to 99.
Whammy (no Dry Signal)
1 (1 octave above)
2 (2 octaves above)
3 (a 2nd below)
4 (a 2nd below reversed pedal action)
5 (a 4th below)
6 (1 octave below)
7 (2 octaves below)
8 (6 octaves below)
Harmony Bends (Dry Signal Added)
9 (a minor 3rd to a Major 3rd)
10 (a 2nd above to a Major 3rd above)
11 (a 3rd above to a 4th above)
12 (a 4th above to a 5th above)
13 (a 5th above to 1 octave above)
14 (1 octave above)
15 (1 octave down)
23
To Next Page
Loading...
Need help?
General
