iii
Important Safety Instructions, continued
20 Do not overload wall outlets or extension cords; this can result in a risk of re or
electrical shock.
21 Never insert objects of any kind into the Joey through openings, as the objects may
touch dangerous voltage points or short out parts. This could cause re or electrical
shock.
22 Do not locate the antenna near overhead light or power circuits, or where it can fall
into such power lines or circuits. When installing the antenna, take extreme care to
avoid touching such power lines or circuits, as contact with them can be fatal.
23 Do not attempt to service the Joey yourself, as opening or removing covers may
expose you to dangerous voltage and will void the Limited Warranty. Refer all
servicing to authorized service personnel.
24 Unplug the Joey from the AC power outlet before cleaning.
25 Do not place the Joey in an enclosure such as a cabinet without proper ventilation.
26 Do not install the Joey in any area where the temperature can be less than 40°F
or more than 113°F. If the Joey is cold to the touch, do not plug it in immediately. Let
it sit unplugged at room temperature for at least 45 minutes before plugging it in.
27 Use an outlet that contains surge suppression or ground fault protection. During an
electrical storm or when the Joey is left unattended and unused for long periods of
time, unplug the power cord from the wall outlet, disconnect the lines between the
Joey and the antenna, and disconnect the telephone line. These actions provide
additional protection against damage caused by lightning or power line surges.
28 Tighten all of the coaxial cable connections only by hand. If you use a wrench, you
may overtighten the connections and damage your equipment.
Proper Care of Your Equipment
• Always handle the Joey carefully. Excessive shock and vibration can damage it.
• If the equipment is turned on and needs to be moved, unplug the equipment and let
it sit for al least 30 seconds before moving it.
• The use of accessories or attachments not recommended by the Joey manufacturer
and voids the Limited Warranty.
• Do not stack the Joey on top of or below other electronic devices as this can cause
heat build-up and vibration.
• On some TVs, the presence of xed images for extended periods of time may
cause them to be permanently imprinted on the screen. Consult your TV user
guide for information on whether this a problem for your TV, what operating/viewing
restrictions apply to avoid this problem, and associated TV warranty coverage.
To Next Page
Loading...
Need help?
General
