3-24
Chapter 3 ADVANCED OPERATION
When paper is loaded on the paper feed
table, only the counted number will be dis-
played. If you press the C button for more
than two seconds, the counter returns to
"0." If you press the Start button without
pressing the C button, folding operations
will resume and the accumulated number
will be displayed on the counter.
Note that you cannot move onto the next
procedure until you place paper on the
paper feed table.
23
Store the cross folding lever.
4-2. Cross Folding Non-Standard Size Paper
Paper other than the six standard size paper are called non-standard size paper. The paper size that
can be cross folded is as follows.
Length(L): 182 to 432 mm/
7.00 to17.00 inches
Width: 128 to 297 mm/5.00 to 11.00 inches
Paper feeding direction
Maximum: 297 (W) x 432 (L) mm/11.00 (W) x
17.00 (L) inches
Minimum: 128 (W) x 182 (L) mm/5.00 (W) x
7.00 (L) inches
* Minimum for cross single fold: 90 (W) x 135
(L) mm/3.54 (W) x 5.31 (L) inches
The following describes the cross single
folding procedures of 300 mm/12.00 inches
long paper as an example.
1
Fold the paper into two according to
Chapter 3 "ADVANCED OPERATION"
"3.Standard Folding of Non-Standard
Size Paper" ( p.3-15).
L
Paper feeding direction
2
Measure the length (L) of the single-
folded paper.
3
Press along the folded line of the
single-folded paper rmly with your
ngers to prevent the paper from
slipping and buckling in the horizon-
tal direction when folded.
To Next Page
Loading...
Need help?
General
