Eaton Ex-Lite N User Manual

37
INM MTL SUM5 Rev 7
DRAFT - 09 June 2021 DRAFT - 09 June 2021
13 AUTO DETECT HARDWARE
To Auto Detect the settings within a SmartAlarm.
• Open the Eaton SmartAlarm conguration software using the “SmartAlarm” quick launch
icon located on the desktop.
• Apply primary power to the SmartAlarm.
• Remove the rubber bung on the front of the SmartAlarm to access the USB
programming port.
• Connect the Eaton supplied USB cable between the PC/Laptop and the SmartAlarm.
• When you initially plug-in the USB cable to the SmartAlarm you will notice a green LED near
the USB port ash to indicate communication.
• From the “Comport” tool bar select the USB Com. port you will be using to communicate
with the SmartAlarm. Note the Comport No varies depending on the devices connected to
each PC and the USB port being used therefore more than one com port may be identied
in the list.
• Use the “”File” menu to select “Auto Detect” and note the green progress bar increases
whilst installation is in progress and once complete an Auto Detect Complete message
appears on the desk top - please select “OK”.
• Once Auto Detect is complete all of the settings shown will be an exact copy of those held
in the associated SmartAlarm.
You are now ready to use the software as required.
Before any conguration changes take place Eaton, recommend a Master copy is saved to the PC/
Laptop using the “File” menu – “Export CSV File” this ensures a master copy is available if you
wish to revert back to the initial settings.

Eaton Ex-Lite N Specifications

General

Brand	Eaton
Model	Ex-Lite N
Category	Lighting Equipment
Language	English