18 type vsa12, vsa12b, vsa16, vsa20, and vsa20a operation and installation instructions MN280063EN May 2017
Withstand test results
The high-potential withstand tests provide information on
the dielectric condition of the recloser and the vacuum
integrity of the interrupters.
If the recloser passes the closed-contacts tests (Tests 1
and 2), but fails the open-contacts test (Test 3), the cause is
likely to be in the interrupter assembly. Retest each phase
individually to determine the failed phase or phases.
If the recloser does not pass Tests 1, 2, or 3, contact an
authorized service center or your Eaton representative.
Replacement parts
Replacement parts for Eaton reclosers are available through
the factory Service Department. To order replacement parts,
refer to the maintenance manual and S260-01 through
S280-01 Distribution Switchgear Parts Guide for catalog
numbers. Contact your Eaton representative for additional
information and ordering procedures.
Factory-authorized service centers
Factory-authorized repair shops are located throughout
the continental United States to provide maintenance,
repair, and testing services for Eaton reclosers. For further
information, contact your Eaton representative.
Factory maintenance classes
The factory Service Department offers recloser maintenance
training classes. These classes, taught by experienced
service technicians, are held at the factory’s inhouse training
facility.
To Next Page
Loading...
Need help?
General
