Eaton MET User Manual

Power-up/reset conditions
When the system first comes up and no error conditions
are detected, the LCD displays the following message:
Self-Test Complete.
(Date/Time Shown)
(PASS)
If error conditions are detected, the LCD will display error
message similar to those that follow:
Self-Test Complete.
Configuration Value
Required!
(ATTENTION...MORE )
Self-Test Complete.
Factory Calibration
Required!
(ATTENTION...MORE )
Self-Test Complete.
Data Acquisition!
(FAILURE...MORE )
If the “Configuration Value Required!” message appears,
refer to Section 3: Initial control programming. Perform
basic programming steps and then initiate a self-test.
Self-Test Complete.
Clock Needs Setting!
(ATTENTION...MORE )
Self-Test Complete.
VR1 Input Voltage
Missing!
(ATTENTION...MORE )
Self-Test Complete.
VR1 Output Voltage
Missing!
(FAILURE...MORE )
Self-Test Complete.
VR1 No Neutral
Sync Signal!
(ATTENTION...LAST)
Consult Section 8: Troubleshooting or contact your
Eaton representative for assistance with specific self-test
messages.
Indication messages
The fourth line of the LCD is used to provide messages
associated with menu mode indications. These indication
messages can be defined with up to 20 characters.
Displayed during Self-Test message:
•
(PASS)
•
(ATTENTION)
•
(ATTENTION...MORE)
•
(ATTENTION...LAST)
•
(FAILURE)
•
(FAILURE...MORE)
•
(FAILURE...LAST)
Displayed when an invalid function code is entered:
•
(INVALID FUNCTION)
Displayed when and invalid security code is entered:
•
(INVALID SECURITY)
Displayed when a parameter cannot be read, written,
or reset because the proper security code has not been
entered:
•
(IMPROPER SECURITY)
Displayed when setting a password that is too weak:
•
(PASSWORD TOO WEAK)
Displayed when edit mode is active:
•
(EDIT)
•
(CONFIRM) (also displayed to prompt the user when
issuing a command from the menu system)
Displayed when a value that has been entered is out the
valid range:
•
(VALUE TOO HIGH)
•
(VALUE TOO LOW)
•
(OUT OF RANGE)
•
(TIMEOUT)
•
(NEG ACKNOWLEDGE)
•
(INVALID DATE)
•
(INVALID TIME)
Displayed when listing alarms or events:
•
(MORE...)
•
(LAST...)
121
INSTALLATION, OPERATION, AND MAINTENANCE INSTRUCTIONS MN225003EN April 2018
CL-7 Voltage Regulator Control

Eaton MET Specifications

General

Brand	Eaton
Model	MET
Category	Cables and connectors
Language	English