Eaton SV9000 User Manual

SV9000 Motor Pump Enhanced Protection Application Page 3 (60)
4 Parameter Group 0
Number Parameter Range Step Default Customer Description
0.1
Application
selection
0-7 1 0
0 = Motor Pump Enhanced Protection
(loaded special application)
1 = Basic Application
2 = Standard Application
3 = Local/Remote
4 = Multi-step Speed Application
5 = PI-control Application
6 = Multi-purpose Control Application
7 = Pump and Fan control Application
0.2
Parameter
Loading
0-5 1 0
0 = Loading ready / Select loading
1 = Load default setting
2 = Read up parameters to user's set
3 = Load down user's set parameters
4 = Read parameters up to the panel
(possible only with the graphical
panel)
5 = Load down parameters from the panel
(possible only with graphical panel)
0.3
Language
Selection
0 0 = English
4.1 Application Selection
With this parameter the active application can be selected. If the device has been ordered from the
factory equipped with the Multipurpose II application this has been loaded in the unit as application 0.
The application has also been set active at the factory. However, check that the value of the
parameter 0.1 is zero when you want to use Motor Pump EP.
If the application is loaded later it has to be activated after loading by setting the value of parameter
0.1 to zero.
4.2 Parameter Loading
See User's Manual chapter 11.
4.3 Language
With this parameter, the language of the graphical panel can be selected.

Eaton SV9000 Specifications

General

Brand	Eaton
Model	SV9000
Category	Controller
Language	English