28
PCI / Plug and Play Setup Page
This page sets up some parameters for devices installed on the PCI
bus and those utilizing the system plug and play capability.
CMOS SETUP UTILITY – Copyright (C) 1985-2003, American Megatrends, Inc.
PCI / Plug and Play Setup
Primary Graphics Adapter PCI
Allocate IRQ to PCI VGA Yes
PCI IDE BusMaster Disabled
Primary
Graphics
Adapter
This item indicates if the primary graphics
adapter uses the PCI or the AGP bus. The
default AGP setting still lets the onboard
display work and allows the use of a second
display card installed in an AGP slot.
Allocate IRQ
to PCI VGA
If this item is enabled, an IRQ will be
assigned to the PCI VGA graphics system.
You set this value to No to free up an IRQ.
PCI IDE
BusMaster
This item enables or disables the DMA
under DOS mode. We recommend you to
leave this item at the default value.
Select which
graphics controller
to use as the
primary boot
device.
Hel
Item
To Next Page
Loading...
Need help?
General
