6
AC power switch and Soft power button
AC power switch and Soft power button
The Fiery X3eTY has a dedicated AC power switch on the back panel and has a Soft
power button on the connector panel (see Figure C).
To use the Soft power button, the AC power switch must be in the ON position. Press
the Soft power button for two seconds to power on; press it for several seconds to power
off and the Fiery X3eTY will be shut down.
The green LED at the Soft power button is on when the Fiery X3eTY is powered on.
F
IGURE
C
Fiery X3eTY AC power switch and Soft power button
Always use the AC power switch before you disconnect the print engine interface cables
or unplug the AC power cable. Cable disconnections require a complete power off. Using
the Soft power button does not power off the Fiery X3eTY completely.
System administrators can use the Soft power button when they do not need to
disconnect the Fiery X3eTY from the print engine or the AC power outlet, such as after
selecting Factory Defaults in Run Setup. (The Fiery X3eTY shuts off automatically when
it is done setting up the factory defaults.)
N
OTE
:
If all connections are good and you think the Fiery X3eTY should be ON but it is
not, then check the LED on the connector panel and the AC power switch on the back
panel. If the green LED is OFF and the AC power switch is ON, then press the Soft
power button for several seconds until the Fiery X3eTY starts up. (Using the Soft power
button does not change the position of the AC power switch.)
AC power switchSoft power button
and green LED
Back panelFiery X3eTY mounted to print engineConnector panel
To Next Page
Loading...
Need help?
General
