Technical Support - A.D.L. 27/83 599 74 12-51 Rev.00
8 ALARMS
8.1 Displaying the alarms to the user
When a problem arises in the appliance, which generates a “WARNING” or an “ALARM”, this is displayed with
three digits, where normally the remaining cycle time is represented.
The alarms displayed to the user are listed below:
ª E10 - Water fill difficulty (tap closed)
ª E20 - Drain difficulty (filter dirty)
ª E40 - Door open
The alarms listed below:
ª EF0 - Water leakage (Aqua Control System)
For its solution, the intervention of a Service engineer is required
While for the alarm:
ª EH0 - Voltage or frequency outside normal values
It is necessary to wait for power supply voltage and / or frequency to restore normal conditions.
The alarms are enabled during the execution of the washing programme. With the exception of alarms
associated with the configuration and the power supply voltage / frequency, which are also displayed
during the programme selection phase.
The door can normally be opened (except where specified) when an alarm condition has occurred, on the
condition that:
• The level of the water in the tub is below a certain level.
• The water temperature is lower than 55°C.
• The motor has stopped.
Certain alarm conditions require a drain phase to be performed before the door can be opened for safety
reasons:
• Cooling water fill if the temperature is higher than 65°C.
• Drain until the analogue pressure switch is on empty, during a max. 3-minute interval.
To Next Page
Loading...
Need help?
General
