Technical Support - A.D.L. 39/83 599 74 12-51 Rev.00
9.3 Description of options
9.3.1 Rinse hold
- During the cycle the intermediate rinses and spins are performed.
- Stops the appliance with water in the tub before the final spin cycle.
- To drain the water, simply press the START / PAUSE button to perform the drain phase and the spin cycle.
9.3.2 Pre-wash
- Adds a pre-wash phase at the start of the cycle with water heating to 30°C (or cold, if selected).
- In COTTON and SYNTHETICS cycles, performs a short spin before passing on to the washing phase.
- This option cannot be selected for WOOL and HAND WASH cycles.
9.3.3 Pre-wash
- Adds a pre-wash phase with heating to 30°C (or cold, if selected) plus 30‘ hold with HAND WASH movement.
- Completes the cycle.
9.3.4 Stains
- Adds a 5-minute motor movement phase after heating to 40°C.
- Water flow to the pre-wash / stains compartment to introduce the special stain-removal product.
- This option cannot be selected for WOOL and HAND WASH cycles.
9.3.5 Super rinse
- Adds two rinses to the COTTON cycle, one to the SYNTHETIC FABRICS – DELICATES cycles.
- Eliminates the spin at the end of washing.
9.3.6 No spin
- It eliminates all
the spin phases.
- It adds three rinses to the COTTON CYCLE and one to the SYNTHETIC FABRICS cycle.
9.3.7 Daily
- Modifies the structure of the COTTONS – SYNTHETICS – DELICATES cycles to obtain good washing
performance in a short space of time.
9.3.8 Super quick
- Modifies the structure of the wash phase of the COTTONS – SYNTHETICS – DELICATES cycles by half a load.
9.3.9 Delayed start time
- Adds a pause before the start of the programme. The delay time is displayed on the three digits.
- See page 12 series 7, page 20 series 8, page 28 series 9.
- To start the cycle immediately after the countdown to the delayed start has already begun:
- Press the START / PAUSE button, cancel the delay time by pressing the relevant button, then press START /
PAUSE again.
To Next Page
Loading...
Need help?
General
