Electrolux Gas Hob User Manual

69
5. Touch the Decreasing Control
to
select the required type of gas.
6. After selecting the type of gas, switch
off the hob touching the main ON/OFF
Control
.
7. Touch the main ON/OFF Control
again to reactivate the hob.
The appliance is automatically set to the
normal “User Mode”.
8. Light all the burners and adjust their
flame to minimum, in order to check the
flame stability (visual check).
9. At the same time, check the flame
aspect (visual check).
If both the flame stability and the flame
aspect are satisfactory, the setting of the
hob for the new gas type is completed.
If the flame stability is not satisfactory, carry
out an additional adjustment as described
in the following paragraph.
Minimum flame adjustment
If it is necessary to adjust the minimum
flame setting, proceed as follows:
1. Carry out the steps described in the
paragraph “Setting the hob for the new
gas type” - points 1, 2, 3, 4 and 5.
2. Light the burner to be adjusted by
touching the Burner Ignition Control .
The burner lights at the maximum flame
level and, after a regular flame is
obtained, it sets at the minimum flame
level .
3. If the minimum level is too low or not
satisfactory to maintain the burner lit,
touch the Increasing
or Decreasing
Control to carry out a fine adjustment
(visual check).
4. Switch off the hob touching the main
ON/OFF Control
.

Electrolux Gas Hob Specifications

General

Brand	Electrolux
Model	Gas Hob
Category	Hob
Language	English