INSTALLATION INSTRUCTIONS | SMART LINE BOILING PAN
14 DOC N° ST0 9183-02 EN | 10-2018
8. CUSTOMER SERVICE, REPAIR AND MAINTENANCE
Service, repair and maintenance work must
only be carried out by Electrolux Profes-
sional or Electrolux partner dealers. Coun-
try-specific and local regulations apply.
This applies in particular to safety and reg-
ulatory installations. A service contract is
therefore recommended.
Before starting any service, repair or mainten-
ance work, the appliances must be disconnec-
ted from the mains supply (turn the main switch
off or remove the fuses from the power supply),
the gas supply turned off and drinking water
pipes closed off.
Parts requiring replacement must be replaced
by original parts from Electrolux Professional.
The warning and information notices fitted to the
appliances must be obeyed by specialist and
customer service staff and must not be removed
or altered.
During service / repair and maintenance work,
distractions and stress factors must be avoided.
As such, unauthorised persons must be kept
away from the appliance. Servicing may be not
carried out on ships at sea.
IMPORTANT!
Danger of fire, explosion and death
• When operating the appliance and during
maintenance, you must make sure there are
no moving parts, such as vents, inside the ap-
pliance. Take extreme care.
• Repairs and service on the appliances must
be carried out when heating elements have
cooled down.
• Any internal electrical wiring in the appliance
and the connections to the earth cable are in
accordance with the respective wiring dia-
grams and must not be modified. All metal
parts which have electrical connections on
them must remain earthed.
• After completion of the maintenance and re-
pair work, the service technician must carry
out checks to ensure all operating modes of
all functional and safety components are in
accordance with the operating instructions.
8.1 Maintenance periods
Similarly constructed appliances are not under
obligation to be certified. They are subjected to
a pressure and function test at the factory in ac-
cordance with the relevant guidelines.
Depending on the frequency and intensity of
use, functional parts must be maintained and
tested consistently at regular intervals. However
this must be at least once a calendar year.
To Next Page
Loading...
Need help?
General
