38 39
CBD6601V
GB
CHANGING A CYCLE
Condition: You can change wash cycle on the condition that the rst selected cycle has only been running a
short time. Otherwise, detergent may already have been released and the water drained from the machine. In
such cases, the detergent compartment must be relled (see the “Filling the detergent compartment” section).
To pause the machine with the door closed, press the Start/Pause button. Hold the Start/Pause button down
for over three seconds to put the machine into stand-by mode. You can then select another cycle and restart
the machine (see the “Starting a wash cycle...” section).
Important! If you open the door during washing, the machine will pause. When you then close the door and
press the Start/Pause button, the machine resumes the selected cycle after 10 seconds.
The cycle lights show the current dishwasher phase:
a) One of the cycle lights is on with a steady light --- stand-by or pause.
b) One of the cycle lights is ashing --- washing is in progress.
At the end of the wash cycle
When the wash cycle has ended, the beeper sounds for 8 seconds and the machine then stops.
• Turn the dishwasher off
1. To turn the dishwasher off, press the ON/OFF button.
2. Turn the tap off!
• Open the door carefully.
Hot chinaware is sensitive to knocks. Before unloading the machine, let the washing-up cool for around 15
minutes.
• Unload the dishwasher
It is normal for the inside of the dishwasher to be wet.
WARNING!
Do not open the door while washing is in progress. Escaping water can cause burns.
STARTING THE MACHINE
Starting a wash cycle...
Pull out the rack (see the “Loading the dishwasher rack” section).
Add detergent.
Put the plug into a power outlet. The machine requires a 220 – 240 V AC, 50 Hz, supply
(The power outlet must have a 10 A fuse, 250 V AC.)
Ensure that the water supply is at full pressure.
Press the cycle button repeatedly to step through the wash cycles in the following order:
ECO -> Glass -> Quick -> Intensive -> Normal
When a cycle has been selected, the corresponding indication light comes on. Next, press the Start/Pause
button. The dishwasher then starts.
Important! When you press the Start/Pause button to pause washing, the cycle light stops ashing and the
dishwasher gives a beep every minute until you press the Start/Pause button to restart.
To Next Page
Loading...
Need help?
General
