GB
77
Changing the program mid-cycle
A wash cycle can only be changed if it has been running for a short time, otherwise the detergent may have already been
released and the dishwasher may have already drained the wash water. If this is the case, the dishwasher needs to be reset
and the detergent dispenser must be relled. To reset the dishwasher, follow the instructions below:
1. Press the Start/Pause button to pause the wash cycle.
2. Press the program button for more than 3 seconds to cancel the program.
3. Press the program button to select the desired program.
4. Press the Start/Pause button, after 10 seconds the dishwasher will start.
3 sec
Forget to add a dish?
A forgotten dish can be added any time before the detergent dispenser opens. If this is the case, follow the instructions
below:
1. Press the Start/Pause button to pause the wash cycle.
2. Wait 5 seconds then open the door.
3. Add the forgotten dishes.
4. Close the door.
5. Press the Start/Pause button, after 10 seconds the dishwasher will start.
After 5 sec
WARNING
It is dangerous to open the door mid-cycle, as hot steam may
scald you.
To Next Page
Loading...
Need help?
General
