To Next Page

To Previous Page

EMC Connectrix B Series DS-5300B Hardware Reference Manual

Installing and Configuring the DS-5300B

Installing a standalone DS-5300B

To install the DS-5300B as a standalone unit:

1. Unpack the DS-5300B and verify the items listed on “Items

required for installation” on page 23.

2. Apply the adhesive rubber feet. Applying the rubber feet onto the

switch helps prevent the switch from sliding off the supporting

surface.

a. Clean the indentations at each corner of the bottom of the

switch to ensure that they are free of dust or other debris that

might lessen the adhesion of the feet.

b. With the adhesive side against the chassis, place one rubber

foot in each indentation and press into place.

3. Place the switch on a flat, sturdy surface.

4. Provide power to the switch as described in “Powering the

DS-5300B on and off” on page 34 .

Note: Do not connect the switch to the network until the IP address is

correctly set. For instructions on how to set the IP address, see “Configuring

the DS-5300B” on page 26.

Questions and Answers:

Need help?

Do you have a question about the EMC Connectrix DS-5300B and is the answer not in the manual?

EMC Connectrix DS-5300B Specifications

General